Description for Pacific Core P5 DP-D5 Plus Distro-Plate with Pump Combo | CL-W264-PL00SW-A
The Pacific Core P5 DP-D5 Plus is a Liquid cooling Distribution plate and D5 pump combo unit built for the Core P5 chassis. This simplifies the tube structure of hard tubing water cooling and adds a smarter way for beginners and experienced modders to present their water-cooled builds.
The Thermaltake Core P5 DP-D5 Plus is a distribution plate with a pre-installed D5 pump, the distro is designed for our Core P5 Chassis allowing you to mouth it directly to the chassis. Furthermore can be synced with our TT RGB PLUS Ecosystem.



Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks
- To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
- Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
- It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
- Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.
Thermaltake recommends the following steps to be taken after completing your water loop setup
- It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
- Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
- DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
- Fill the reservoir to the top as it will prevent air from going into the pump
- If necessary tilt the system slightly from side to side to bleed the air out of the loop.
- Place some paper towels under fittings and joining points to test for leaks.
- Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop
- Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
- Coolant might fade over time.
Specifications for Pacific Core P5 DP-D5 Plus Distro-Plate with Pump Combo | CL-W264-PL00SW-A
- CL-W264-PL00SW-A
- 43266
- 17 May, 2020
- 3.25 Kg
- 11.00 cm x 58.00 cm x 27.01 cm